Sterling QVF Manual de usuario descargar pdf

STEEL CONSTRUCTION* WOOD CONSTRUCTION JOISTS*

IISK-2

J30-03386

HEATER MOUNTING

INSTALLATION INSTRUCTIONS & PARTS LIST

FOUR TO TWO-POINT SUSPENSION KIT

A. PRIOR TO INSTALLATION: Prior to adapting any existing four-point suspension, determine that it is secure by inspecting the

existing heater mounting, wood joists, I-beams, bolts washers and clamps.

B. CLEARANCE: Every gas appliance shall be located with respect to the building construction and other equipment

so as to permit access to the appliance. Clearance between the vertical walls and vertical sides of the appliance shall be

no less than 18 inches. Minimum clearance between top of the appliance and the ceiling is 6 inches. Minimum clearance

from combustibles to the bottom of the unit is 12 inches. However, this bottom clearance should be maintained at 21 inches

for access to the burners. The minimum clearance from combustible to the flue collector is 6''. Adequate clearance must be

maintained around air openings into the combustion chamber.

KIT CONTENTS

1. (2) BRACKETS, 12 GA. C.R.S.

2. (2) BOLTS, 1/2''-13 UNC* x 3'' lg.

3. (4) WASHERS, PLAIN

4. (2) WASHERS, LOCK

5. (2) NUTS, 1/2''-13 UNC

*1/2" diameter, 13 threads per inch

(Unified National Course).

ADAPTS FOUR-POINT TO TWO-POINT BALANCED SUSPENSION

FOR PROPELLER UNIT HEATERS (QVF-100/400 & QVEF-100/400)

* ALL HANGING HARDWARE & WOOD BY OTHERS.

HVAC PRODUCTS

260 NORTH ELM ST., WESTFIELD, MA 01085

TEL: (413) 564-5540 FAX: (413) 562-5311

www.sterlinghvac.com

HVAC PRODUCTS

STEEL CONSTRUCTION* WOOD CONSTRUCTION JOISTS*IISK-2J30-03386HEATER MOUNTINGINSTALLATION INSTRUCTIONS & PARTS LISTFOUR TO TWO-POINT SUSPENSION KIT

Modelos relacionados QVEF | QVSF |

Sin comentarios