Sterling 71110116-96 Guía de instalación descargar pdf (Pagina 23)

7. Prepare the Wall Surrounds

For Baths with Wall Surrounds Only

Prepare the Plumbing End Wall

NOTE: Holes for the mixer valve, shower, and spout must be cut into the plumbing

end wall.

Refer to the trim manufacturer’s instructions for necessary hole sizes. Verify that

any escutcheon, ﬂange, or cover plate is large enough to cover the hole for the

component.

Lay out and mark the centerline location for the mixer valve, shower, and spout

on the back side of the end wall. (1)

Drill 1/4″ (6 mm) pilot holes at the marked locations from the back side of the

end wall. (2)

CAUTION: Risk of product damage. Failure to follow directions regarding your

blade’s cutting direction may damage the plumbing end wall ﬁnish. Cut the holes

from the front side of the wall for: hole saws, rotary tools, hand-held jigsaws, or

other saws with a blade that cuts on the push stroke. Cut the holes from the back

side of the wall for other reciprocating saws with a blade that cuts on the pull

stroke.

Carefully cut the ﬁtting holes to the correct diameter. (3) Refer to the trim

manufacturer’s instructions for proper diameter.

Carefully clean any debris from the bath to reduce the risk of surface damage.

Optional Accessories

Refer to the accessory manufacturer’s instructions for proper installation.

If drilling is required, mark and drill the mounting locations for your accessory on

the back side of the wall. Do not secure the accessory at this time.

Drill pilot holes on back of wall.

Percer les trous-pilotes sur

le mur arrière.

Taladre los orificios guía en

la pared posterior.

Cut holes through front of wall.

Découper les orifices

dans le mur.

Perfore los orificios a través

del frente de la pared.

Mark center of valve

and spout.

Marquer le centre de

la valve et du bec.

Marque el centro de la

válvula y del surtidor.

Sterling 23 1064908-2-C

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

Sin comentarios

Sterling 71110116-96 Guía de instalación Pagina 23